PATC Course: Programming ARM based prototypes

PRACE Trainings

Data: 16/May/2013

Place:

The course will take place in
Barcelona Supercomputing Centre,
within the UPC Campus Nord premises.

Room VS219, Vertex Building (green on the map)
S indicates that the room is 2 floors below the entrance level.

Target group: Standard HPC users, some knowledge of multicore and GPU-accelerated systems is desirable, but not required. Level: ITERMEDIATE: for participants with some theoretical and practical knowledge (All courses are designed for specialists with at least 1st cycle degree)

Cost: There is no registration fee. The attendees would need to cover the expenses for travel, accommodation and meals.

Primary tabs

Course Outline:

Session 1 9:00 am (2h):

  1. The Montblanc Project
  2. ARM based machines: Architecture Overview
  3. Discussion

Session 2 (1h + 1h hands-on):

Using ARM based machines (How to get access, Job Execution, Support) ( 1:30h )

Lunch Break (13:00 to 14:00)

Session 3 (1h +  1h hands-on ):

Developing application on ARM based machines(GNU tool chain, examples, etc…)

END of COURSE